How to add a user code on my Smartcode touchscreen?
Adding User Codes with the Mastercode EnabledThe procedure for adding user codes is different when the Mastercode is enabled. For instructions on how to add user codes when the Mastercode is disabled, see the Installation and User Guide that came with your lock.
1. Keep door open. Press the Program button once. The Checkmark will flash five times and you will hear five beeps.
2. Press Checkmark symbol once.
3. Enter Mastercode.
4. Press Lock symbol once
5. Enter new user code.
6. Press Lock symbol once.
If programming is successful, the Checkmark will illuminate and you will hear one beep.
If programming is unsuccessful, the “X” pattern will flash three times with three beeps. Make sure the user code is not a duplicate and that it is between 4 and 8 digits during your next attempt. Make sure the lock has room for an additional code. If all user codes are filled, delete a code to make room for this one. Make sure to enter a valid Mastercode in step 3.
7. While the door is open and locked, test the user code to make sure it unlocks the door.
Adding User Codes with the Mastercode Diabled
Programming Timeout
During programming, if the screen is not pressed for 20 seconds, the system will time out (indicated by three beeps and the “X” pattern flashing three times), and you will need to restart the procedure.
1. Make sure the door is open. Press the Program button once.
2. Press checkmark symbol once.
3. Enter user code. A total of 16 user codes may be programmed. Each user code must be a unique code between 4 and 8 digits.
4. Press lock symbol once.
5. Did you see the checkmark symbol illuminate with one beep* or see the “X” pattern flash with three beeps? (*Beeping sound will only be heard if switch #3 (on the lock interior) is in the on positon.)
Checkmark symbol with one beep - Programming was successful.
“X” pattern with three beeps - Programming was unsuccessful. Make sure the user code is not a duplicate and that it is between 4 and 8 digits during your next attempt. Make sure the lock has room for an additional code. If all user code positions are filled, delete a code to make room for this one.